BEST 2200 COLD | Cold Two Component Hydraulic Extrusion Pump

BEST 2200 COLD

Cold Two Component Hydraulic Extrusion Pump

It is used for extruding polysulfide, polyurethane, silicone and structural silicone between sheets of insulated glasses. It is recommended to use Best Cooler freezers to increase performance and reduce waste material.

Share

  • • Materials used : polysulfide ( thiokol ), polyurethane, silicone and structural silicone
  • • Easy adjusting of mixing ratio between 1/5 and 1/15 by dosage pump
  • • Auto-stop system against unexpected over pressure cases
  • • Pressure hoses are resistant to high pressure and chemical corrosion
  • • Temperature control system for A Component hollow plate
  • • Special design of A component plate for low loss of material
  • • Strong and easy cleanable special design mixing group
  • • By-pass system for preventing the curing of material in stand-by mode
  • • Material filter for B component
  • • Desiccant unit for B component in polyurethane extruder
  • • Materials used : polysulfide ( thiokol ), polyurethane, silicone and structural silicone
  • • Easy adjusting of mixing ratio between 1/5 and 1/15 by dosage pump
  • • Auto-stop system against unexpected over pressure cases
  • • Pressure hoses are resistant to high pressure and chemical corrosion
  • • Temperature control system for A Component hollow plate
  • • Special design of A component plate for low loss of material
  • • Strong and easy cleanable special design mixing group
  • • By-pass system for preventing the curing of material in stand-by mode
  • • Material filter for B component
  • • Desiccant unit for B component in polyurethane extruder